3D Printing
View
Options
History
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
Introduction
Details
Guide Steps
Review
Quiz
Using your pliers, gently place the heat sock over the heater block, then nudge it into place.
The big rectangular cut should face to the right in order to make space for the thermistor and heater cartridge wires.
Even with the cut, my heat socks were just weirdly shaped enough to not fit perfectly, and one end kinda dangles a bit. As long as it doesn’t go past the nozzle, it should be fine
« Previous
Next »
Your contributions are licensed under the open source Creative Commons license.
Next line
Previous line
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.