Skip to main content
/

Site Navigation

Your Account

Choose Language

Help

Step Type:

Drag to rearrange

BOTH SECTIONS END HERE

Due to the new bed springs being longer when compressed, I found it necessary to shift the Z end stop up by a couple millimeters. Not doing this caused my nozzle to dig into the bed.

To do this, auto home the printer as if to level it, then move the gantry up about 4 millimeters, loosen the two screws on the side, and fiddle the end stop upwards until it clicks. Tighten it back down once you’re done.

Note: You may need to repeat this steps a couple times so that the endstop is high enough that you can do all of the normal leveling actions.

Your contributions are licensed under the open source Creative Commons license.