ENGR-11A Spring 2024
View
Options
History
1
2
3
4
5
6
7
8
9
Introduction
Details
Guide Steps
Review
Quiz
When the prints are finished, you should grab a flush cutter to remove the supports.
Depending on the printing accuracy of your printer, the surface of the model may be rough. You should sand it with sandpaper. Caution: sanding with sandpaper generates micro-plastic dust, which can post health risks if inhaled or in contact with mucous membranes. Please do this under professional guidance.
« Previous
Next »
Your contributions are licensed under the open source Creative Commons license.
Next line
Previous line
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.