You're viewing a previously published revision of this guide.  View latest revision

Older
Jan 17, 2022 - 07:01:05
Jan 17, 2022 - 08:01:23 Jan 17, 2022 - 08:01:06 Jan 17, 2022 - 08:01:22 Jan 17, 2022 - 08:01:10 Jan 17, 2022 - 08:01:57 Jan 17, 2022 - 08:01:49 Jan 17, 2022 - 08:01:19 Jan 17, 2022 - 08:01:23 Jan 17, 2022 - 08:01:00 Jan 17, 2022 - 08:01:55 Jan 17, 2022 - 08:01:46 Jan 17, 2022 - 08:01:04 Jan 17, 2022 - 08:01:12 Jan 17, 2022 - 08:01:11 Jan 17, 2022 - 08:01:12 Jan 17, 2022 - 07:01:05 Jan 17, 2022 - 07:01:55 Jan 17, 2022 - 07:01:44 Jan 17, 2022 - 07:01:49 Jan 17, 2022 - 07:01:45 Jan 17, 2022 - 07:01:42 Jan 17, 2022 - 07:01:16 Jan 17, 2022 - 06:01:10
Newer

Replace Ender 3 Heater Block

Written By: Katherine
  • Comments: 0
  • Favorites: 0

Difficulty

Moderate

Steps

2

Time Required

00:30:00

Sections

1

Flags

2

In Progress

In Progress

This guide is currently being written. Reload periodically to see the latest changes.

User-Contributed Guide

User-Contributed Guide

This guide is not managed by the site's staff.

Quiz

0

  1. We only need the hardware, so remove the included wiring and pneumatic coupling. Unthread the attached coupling and pull off the heat sock to reveal the screws holding the assembly together Loosen the two indicated screw without removing them until the electronics slide out of their holes smoothly. Do not retighten

    • We only need the hardware, so remove the included wiring and pneumatic coupling.

    • Unthread the attached coupling and pull off the heat sock to reveal the screws holding the assembly together

    • Loosen the two indicated screw without removing them until the electronics slide out of their holes smoothly. Do not retighten

  2. Preheat your printer to 200-230 degrees celsius Remove the two screws on the fan cover, and set it aside on the gantry Consider everything under the cover to be hot until you set the printer to cool down

    • Preheat your printer to 200-230 degrees celsius

    • Remove the two screws on the fan cover, and set it aside on the gantry

    • Consider everything under the cover to be hot until you set the printer to cool down

    • Unscrew the pneumatic coupling and pull off the heat sock

Author

Katherine

Member since: 9/14/20

25 Reputation

2 Guides authored

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 4

All Time: 165