Skip to main content

Changes to Step #64

Edit by Katherine

Edit approved by Katherine

Before
After
Unchanged

Step Lines

+[title] Upgrading the Ender (4/5) Extrusion upgrades (Bowden Upgrades (3/5))
+[* 1] Connect the coupling to the tube by just inserting the bowden into the little plastic ring. That ring should be compressed towards the brass section and accept the tube. Both parts should now be stuck together without any space for the bowden to move in and out.
+[* 1] Then measure out the length you want the bowden to be at, about the same as the stock bowden, and carefully cut it to as flat as possible.

Image 1

No previous image

New image

Added