Skip to main content

Changes to Step #63

Edit by Katherine

Edit approved by Katherine

Before
After
Unchanged

Step Lines

+[title] Upgrading the Ender (4/5) Extrusion upgrades (Bowden Upgrades (2/5))
+[* 1] Safety note: While doing this, hold onto the fan housing and not the gantry arm to avoid burning yourself
+[* 1] Turn on the printer and heat it to about 210 C, push the plastic ring at the top of the hotend coupling down, and pull the bowden out.
+[* 1] Operational note: My coupling was old and worn in, so I had to unscrew it with the wire strippers and pull the coupling out before separating the two pieces.

Image 1

No previous image

New image

Added

Image 2

No previous image

New image

Added