Changes to Step #58
Step Lines
| + | [title] Upgrading the Ender (4/5) Extrusion upgrades (Motor Upgrades (14/16)) |
|---|---|
| + | [* 1] Place the filament drive screw onto the shaft, and hold it high enough so that the teeth and the bearing are at about the same height. |
| + | [* 1] Tighten the two grub screws. |
| + | [* 1] Note: The motor shaft has a flattened section that one of the grub screws should be tightened into and against, thereby helping to keep the gear from rotating on the shaft |
Image 1
No previous image
Added