Skip to main content

Changes to Step #57

Edit by Katherine

Edit approved by Katherine

Before
After
Unchanged

Step Lines

+[title] Upgrading the Ender (4/5) Extrusion upgrades (Motor Upgrades (13/16))
+[* 1] Place the motor and its frame against each other, then tighten the screws through the frame and into the four attachment points on the motor.
+[* 1] The first three screws can be tightened down, but the idler hinge screw should be just tight enough to move but not tight enough to inhibit the idler’s ease of motion.

Image 1

No previous image

New image

Added

Image 2

No previous image

New image

Added