Skip to main content

Changes to Step #55

Edit by Katherine

Edit approved by Katherine

Before
After
Unchanged

Step Lines

[title] Upgrading the Ender (4/5) Extrusion upgrades (Motor Upgrades (11/16))
-[* 1] Note: The Extruder motor is held up by three screws and nothing else: Removing these screws will cause your motor to fall to the table
+[* 9] Note: The Extruder motor is held up by three screws and nothing else: Removing these screws will cause your motor to fall to the table
[* 1] Holding the extruder motor in place, undo the three remaining screws securing the frame in place.
[* 1] Once that’s done, you can just remove the frame and the motor