Changes to Step #55
Step Lines
| + | [title] Upgrading the Ender (4/5) Extrusion upgrades (Motor Upgrades (11/16)) |
|---|---|
| + | [* 1] Note: The Extruder motor is held up by three screws and nothing else: Removing these screws will cause your motor to fall to the table |
| + | [* 1] Holding the extruder motor in place, undo the three remaining screws securing the frame in place. |
| + | [* 1] Once that’s done, you can just remove the frame and the motor |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added