Skip to main content

Changes to Step #39

Edit by Katherine

Edit approved by Katherine

Before
After
Unchanged

Step Lines

+[title] Upgrading the Ender (2/5) Build plate upgrade (7/7)
+[* 1] BOTH SECTIONS END HERE
+[* 1] Due to the new bed springs being longer when compressed, I found it necessary to shift the Z end stop up by a couple millimeters. Not doing this caused my nozzle to dig into the bed.
+[* 1] To do this, auto home the printer as if to level it, then move the gantry up about 5 millimeters, loosen the two screws on the side, and fiddle the end stop upwards until it clicks. Tighten it back down once you’re done.
+[* 1] Note: You may need to repeat this steps a couple times so that the endstop is high enough that you can do all of the normal leveling actions.