Skip to main content

Changes to Step #36

Edit by Katherine

Edit approved by Katherine

Before
After
Unchanged

Step Lines

+[title] Upgrading the Ender (2/5) Build plate upgrade (6A/7)
+[* 1] THIS IS SECTION A
+[* 1] Reverse the steps that you took to remove the build plate
+[* 1] Place each spring between the build plate and the metal gantry, then snake a screw through all three and thread it in place with the tuning wheel.
+[* 1] Take care when finessing a spring into the bracket holding the thermistor and heater cartridge wires.

Image 1

No previous image

New image

Added

Image 2

No previous image

New image

Added