Changes to Step #26

Edit by Katherine —

Edit approved by Katherine

Before
After
Unchanged

Step Lines

[title] Upgrading the Ender (1/5) X/Y Axis movement (X axis movement (3/6))
-[* 1] Warning: This motor is also under belt tension, as well as potentially being significantly higher off the table than the Y axis motor
+[* 9] Warning: This motor is also under belt tension, as well as potentially being significantly higher off the table than the Y axis motor
[* 1] Remove the four screws holding the motor in, making sure to hold both it and the black cover in place while doing so.
[* 1] Once all four screws are gone, you can let the cover dangle by its wire and just make sure the motor doesn’t drop out of its spot