Changes to Step #26
Step Lines
| + | [title] Upgrading the Ender (1/5) X/Y Axis movement (X axis movement (3/6)) |
|---|---|
| + | [* 1] Warning: This motor is also under belt tension, as well as potentially being significantly higher off the table than the Y axis motor |
| + | [* 1] Remove the four screws holding the motor in, making sure to hold both it and the black cover in place while doing so. |
| + | [* 1] Once all four screws are gone, you can let the cover dangle by its wire and just make sure the motor doesn’t drop out of its spot |
Image 1
No previous image
Added
Image 2
No previous image
Added