Skip to main content

Changes to Step #21

Edit by Katherine

Edit approved by Katherine

Before
After
Unchanged

Step Lines

+[title] Upgrading the Ender (1/5) X/Y Axis movement (Y axis movement (6/8))
+[* 1] Push the build plate back and forth a couple of times to make sure the belt will run smoothly in the middle of the gear and won’t touch the bar it runs through.
+[* 1] If it doesn’t do this, move the gear along its axle until it does, then tighten it down so that all movements made by the stepper will also translate to the belt

Image 1

No previous image

New image

Added

Image 2

No previous image

New image

Added