Changes to Step #17

Edit by Katherine —

Edit approved by Katherine

Before
After
Unchanged

Step Lines

[title] Upgrading the Ender (1/5) X/Y Axis movement (Y axis movement (2/8))
-[* 1] Warning: The motor is under tension from the belt, and might fly out of its bracket, off the table, and down a well if something doesn't hold it in place
+[* 9] Warning: The motor is under tension from the belt, and might fly out of its bracket, off the table, and down a well if something doesn't hold it in place
[* 1] Undo the four hex bolts while using your hand to hold the motor in place.
[* 1] Gently tilt the motor housing backwards and out of its bracket, then disconnect its wire and put everything in a safe place