Skip to main content

Changes to Step #8

Edit by Coco M1lk

Edit approved by Coco M1lk

Before
After
Unchanged

Step Lines

+[title] Check the prints
+[* 1] When the prints are finished, you should grab a flush cutter to remove the supports.
+[* 1] Depending on the printing accuracy of your printer, the surface of the model may be rough. You should sand it with sandpaper. ***Caution***: sanding with sandpaper generates micro-plastic dust, which can post health risks if inhaled or in contact with mucous membranes. Please do this under professional guidance.

Image 1

No previous image

New image

Added

Image 2

No previous image

New image

Added