Skip to main content

Changes to Step #7

Edit by Coco M1lk

Edit approved by Coco M1lk

Before
After
Unchanged

Step Lines

+[title] Printing the models
+[* 1] This step varies depending on the printer selected. If following this guideline, you should choose the Prusa MINI+ as your printer.
+[* 1] Check that the printer is well calibrated.
+[* 1] Check that the filament loaded in the printer is consistent with the setting in the gcode file.
+[* 1] Check that the printer has enough filament loaded to finish the print.
+[* 1] Check that the filament has no visible damage.
+[* 1] Insert the disk drive with the prepared gcode file to the printer and start the print.